Kitz ADSL Broadband Information
Home Broadband ISPs Tech Routers Wiki Forum
 
     
   Compare ISP   Rate your ISP
 

Difference between revisions of "Broadcom CLI"

From kitz wiki
Jump to: navigation, search
(CLI commands for Broadcom-based routers)
(CLI commands for Broadcom-based routers)
Line 25: Line 25:
 
All Broadcom-based ADSL routers have very similar CLI command sets. Listed below are a few of the more frequently used commands.
 
All Broadcom-based ADSL routers have very similar CLI command sets. Listed below are a few of the more frequently used commands.
  
'''Note regarding Netgear routers'''
+
=== Note regarding Netgear routers ===
  
 
Netgear routers use a slightly modified version of the Broadcom CLI command set. The command which is used most often is 'adsl' with various parameters, but in Netgear routers this command is replaced by 'adslctl'. On this page we will use 'adsl', but Netgear users will need to substitute 'adslctl'.
 
Netgear routers use a slightly modified version of the Broadcom CLI command set. The command which is used most often is 'adsl' with various parameters, but in Netgear routers this command is replaced by 'adslctl'. On this page we will use 'adsl', but Netgear users will need to substitute 'adslctl'.

Revision as of 09:30, 24 December 2011

This page is incomplete

Routers using Broadcom chipsets

Broadcom chipsets are widely used in ADSL routers, and most incorporate a very similar CLI command set, accessed through its telnet interface. It should be noted though that a number of ISP customised versions of these routers have the telnet interface disabled. This is an incomplete list of routers which have Broadcom chipsets and support telnet:

BCM 6338 chipset

  • D-Link DSL-2540B

BCM 6348 chipset

  • Netgear DG834GT, DG834v4, DG834Gv4, DGN2000
  • D-Link DSL-2640B

BCM 6358 chipset

  • Billion 7700(N), 7800(N)
  • D-Link DSL-2740B
  • Netgear DGN2200

CLI commands for Broadcom-based routers

All Broadcom-based ADSL routers have very similar CLI command sets. Listed below are a few of the more frequently used commands.

Note regarding Netgear routers

Netgear routers use a slightly modified version of the Broadcom CLI command set. The command which is used most often is 'adsl' with various parameters, but in Netgear routers this command is replaced by 'adslctl'. On this page we will use 'adsl', but Netgear users will need to substitute 'adslctl'.

help command

adsl command